Countersink Priming 13-03

Rather than spot prime as suggested by Vans, I couldn’t face over 1000 holes! I decided to prime the top of the spar flanges … although a bit of work setting up to spray etc, in the long run I reckon it was a bit quicker. Also, I found a few places along the flange edges that hadn’t been deburred very well, leaving a possible source of scratches on the wing skins. So I removed these, hence those places needed priming as well.

bic1gE9pSPGpka5koQuVcw.jpg

 

 

n2oGiMxxStWI+2D+ZFnE3g

All done, ready to tackle those nutplates!


Aileron Brackets

I also deburred, final drilled & primed the aileron brackets.

IMG_3032.jpg

 

 

 

Be the first to comment on "Countersink Priming 13-03"

Leave a comment

Your email address will not be published.


*