28-02 to 04 Riveting Stiffeners & Doublers

I used the C-Frame to help with back riveting the antenna doublers.

A mushroom set in the C-Frame underneath the workpiece seems to work a treat.


IMG 2578

I was worried about dropping something on the skins during all this, so used cardboard for protection!


IMG 2580

The Muffler Hanger Angles are riveted to the doublers/tunnel sides with 470AD4-5’s. I tried squeezing these on one side, which worked OK, but I found that back-riveting the other side gave better results … it was hard to prevent the tunnel sides from flexing during the squeeze process.


A quick little job to attach the nut plates to the Fuel Pump Brackets.

IMG 2581

Be the first to comment on "28-02 to 04 Riveting Stiffeners & Doublers"

Leave a comment

Your email address will not be published.


*