46B-10 to 12 Gear Leg Fairings

We are going to fit 6.00-6″ wheels & hence larger spats, hoping to increase ground clearance & improve operational robustness on grass strips.

Section 46B actually begins with fabricating the spats, but as I’m waiting for the Sky Design Engineering spats to arrive from the US, I thought I’d press on with the Gear Leg Fairings.


IMG 7597

The first job is to trim the ends, marked by scribe lines in the moldings.


IMG 7598

After trimming close to the lines with the Dremel disc, the usual fine tuning with sandpaper.


IMG 7599

The fairing trailing edges will be secured together by hinges … with a removable pin so that they can be prised open when attaching/removing from the gear legs.

Because the trailing edges are not yet joined, their fit together must first be longitudinally adjusted so that the fairings are not twisted.

Then manual showed a picture of a C-Frame being used to position the fairings on their leading edges. Seemed a good plan, so I followed suit …


IMG 7602

… and then used a square to align the two ends.


IMG 7603

Once square, the trailing edges are taped in postion, holes drilled, and then clecos can be inserted to lock the alignment when required.


IMG 7659

You then place hinges into the trailing edge (TE) V, marking the location.

The idea is to place the hinges such that the TE’s will be held together with a slight pressure.

Obviously it’s pretty critical to get this right, otherwise you risk an annoying gap at the fairing TE’s.

I decided to mark a position slightly above the hinges’ natural resting position (approx 1/32″), hoping to ensure a slight closing pressure.


IMG 7607

Now this is where the manual didn’t have a good idea! The steps have been written assuming you have fairings without any grey gel coat, so you can see marks on the hinges to match drill … hmmm?

After some more head scratching I came up with a plan:

I drilled the rivet holes in a hinge half first, and then clamped the hinge and fairing on the edge of the workbench, ensuring they were carefully aligned with the position marks. The clamps were really effective in locking it all in position.


IMG 7606

I then used a long #40 drill to match drill into the fairing.

This does mean accepting lots of holes in your bench, in order to allow clecos!


IMG 7608

Once one hinge half is fixed, the second half is easier and can follow the Vans manual steps … but because of the gel coat, you will need to mark out the rivet holes on the fairing rather than the hinge.


IMG 7611

Be careful as you drill, since it’s easy to let the drill impact the opposite hinge half due to the small gap … guess how I know!


IMG 7612

The rivet holes are countersunk using the hinges to guide the countersink cutter, and keep it from elongating the holes in the fairing.


IMG 7613

As usual, lots of holes.

With bated breath I temporarily inserted the hinge pins at this point to check that the TE’s were nicely closed up … success.


IMG 7620

After priming/painting the hinges, a squeezer soon sets the rivets.


IMG 7621

A long sanding block made trimming the TE flanges nice & straight easy.


IMG 7622

The manual advises a 1″ bend for the upper end of the pins.


IMG 7623

I also trimmed a little off the other end of each pin so it didn’t protrude as far from the bottom.


IMG 7634

I used small amounts of filler to hide any undulations along the rivet line.


The leg fairings have turned out just fine, so the next task is to trim and fit the Upper Intersection Fairings.

IMG 7633

1 Comment on "46B-10 to 12 Gear Leg Fairings"

  1. Gorgeous as always Steve. Congrats.

Leave a comment

Your email address will not be published.


*