G STRV-banner%20-%20small

OP-43 Access Panel Installation

Having looked at the space and number of proposed Avionic boxes to fit into that space, I reckon I’m going to have to use the area in front of the F-01455 Sub Panel.

So I admitted defeat and decided to fit the newly released optional access panels in the F-01471 Forward Top Skin, to help with avionics installation.

Marking Out

IMG_3987

The panel kit is designed for several RV models, so a little time has to be spent ensuring the Access Rings are clecoed in the correct position and orientation.

Vans have provided temporary positioning tabs, applicable to the different models, so all straightforward.

IMG_3989

The instructions suggest you match drill the screw holes #19 into the skin at this stage.

Consider an initial match drill to #30 in screw holes

This is because the next stage is to cleco on the VA-258B Access Panels to the skin so you can accurately trace around the edges of the access panels with a fine tip marker. Unless you have some massive clecos this will be a difficult with #19 holes!

Update: See comment below suggesting an alternative method of bolting four #8 screws into the first four corner holes drilled to hold VA-258B in place, then continuing with the procedure.

Cutting

IMG_3990

I used a Dremel SC409 thin metal cutting blade to make the initial cut.

IMG_3993

And then fine tuned for an accurate fit with some elbow grease and a file.

IMG_3992

Obviously the closer you risk the initial cut the less filing … but I was a chicken so it took a while : )

IMG_3994

Then easy dimpling … if you do this job before fitting the Top Skin!

Trimming

IMG_3997

I clecoed on the Top Skin to check everything fitted …

IMG_3996

… and as advised in the instructions, there was a small area of the VA-258A Access Rings to remove to clear a rib flange.

IMG_4053

I back riveted on the nutplates.

Sticky Stuff

IMG_4068

And then another Proseal adventure, so out came the masking tape to keep the sticky monster under control.

IMG_4069

I overdid the Proseal I think, but I don’t want rain getting into the avionics bay!

IMG_4070

I back riveted the Access Rings to the skins, with the masking tape working its magic.

All finished. It took a few hours work but hopefully will pay dividends later?

IMG_4072

3 comments on OP-43 Access Panel Installation
  1. J M Tipton

    May I suggest where you ‘Final Drill 16x #19 holes’ one can use (yes we don’t have #19 Clecos) #8 screws, four bolted into the first four corner holes drilled, would hold VA-258B in place, then continue with the procedure ~

  2. Steve

    Good idea John, that would work well.

  3. Brian Bertsch

    Hi Steve
    Now that you’re flying, are you glad you installed these optional access panels? Would you do it again?

Leave a Reply

Your email address will not be published. Required fields are marked *